Hawking Technology Hawking HWPS1UG User Manual download pdf (Page 71)

following BOOTP configuration. To rebuild the NIS map,

please refer to your system documentation.

To configure the IP address data for the BOOTP server, you

will need to log in as the host of the BOOTP server with

superuser (root) admin rights. Perform the following steps to

add address entries:

1. Optionally, assign a name corresponding to the print

server’s IP address. You can add this address to the /etc/hosts

file, by adding the following line:

203.66.191.12 pserver

2. Add an entry to the host’s /etc/bootptab file, similar to the

following:

hostname:\

:ht=1:\

:ha=print_server_ethernet_address:\

:ip=print_server_ip_address:

Lines should be indented with tabs.

Where hostname is the device name of the HWPS1UG; the ht=1

tag specifies that the hardware type is Ethernet. The ha= tag

specifies that the Ethernet address of the HWPS1UG is the

Node ID located on the print server. The ha tag must be

preceded by the ht tag. The ip= tag should correspond to the IP

address you want to assign to the print server.

For example, below is an example of a print server with the

following configuration:

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 162 163

No comments

Hawking Technology Hawking HWPS1UG User Manual Page 71