Hawking Technology HWR54G User Manual download pdf (Page 22)

Wireless Router User Guide

DHCP

What DHCP Does

A DHCP (Dynamic Host Configuration Protocol) Server allocates a valid IP address to a

DHCP Client (PC or device) upon request.

•

The client request is made when the client device starts up (boots).

•

The DHCP Server provides the Gateway and DNS addresses to the client, as well as

allocating an IP Address.

• The Wireless Router can act as a DHCP server.

• Windows 95/98/ME and other non-Server versions of Windows will act as a DHCP

client. This is the default Windows setting for the TCP/IP network protocol. However,

Windows uses the term Obtain an IP Address automatically instead of "DHCP Client".

•

You must NOT have two (2) or more DHCP Servers on the same LAN segment. (If your

LAN does not have other Routers, this means there must only be one (1) DHCP Server on

your LAN.)

Using the Wireless Router's DHCP Server

This is the default setting. The DHCP Server settings are on the LAN screen. On this screen,

you can:

•

Enable or Disable the Wireless Router's DHCP Server function.

•

Set the range of IP Addresses allocated to PCs by the DHCP Server function.

You can assign Fixed IP Addresses to some devices

while using DHCP, provided that the Fixed IP Addresses

are NOT within the range used by the DHCP Server.

Using another DHCP Server

You can only use one (1) DHCP Server per LAN segment. If you wish to use another DHCP

Server, rather than the Wireless Router's, the following procedure is required.

1. Disable the DHCP Server feature in the Wireless Router. This setting is on the LAN

screen.

2. Configure the DHCP Server to provide the Wireless Router's IP Address as the Default

Gateway.

To Configure your PCs to use DHCP

This is the default setting for TCP/IP under Windows 95/98/ME.

See Chapter 4 - Client Configuration for the procedure to check these settings.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 93 94

No comments

Hawking Technology HWR54G User Manual Page 22