Hawking Technology HNC210 User Manual download pdf (Page 11)

Each available camera will be displayed in the camera list

with its MAC address, current default IP address, and model

number. (NOTE: The Setup Wizard may display an IP

address for the camera that is already consistent with your

network [LAN] settings, rather than the default one.) In the

camera list, click on the camera you would like to configure so

that it is highlighted blue, and then click Next. (If you are

unsure about which camera you would like to configure, you

can compare its MAC address displayed in the camera list to

the one printed on the label on the underside of the camera.)

NOTE: If the camera list does not display any available

cameras, you should:

a. Click on the “Rescan Camera” button, and

b. Make sure that all available similar network cameras are

connected properly to the network.

If neither option above is successful, you can also perform a

factory default reset by holding down the “Reset” button on

the back panel of the camera for at least five seconds. Then,

allow about 45 seconds to one minute for the camera to

complete the reboot process. This should easily resolve the

issue.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

No comments

Hawking Technology HNC210 User Manual Page 11