Hawking-technology 202-10248-01 User Manual download pdf (Page 27)

GS108T Smart Switch Hardware Installation Guide

Installation 4-3

v1.0, March 2007

Figure 4-1 Connecting Devices to the Switch

Connect each device to an RJ-45 network port on the switch’s front panel (see Figure 4-1) using a

Category 5 (Cat5) unshielded twisted-pair (UTP) cable with RJ-45 connectors.

Step 5: Applying Power

Because the NETGEAR GS108T Gigabit Smart Switch has no ON/OFF switch, AC power must

be controlled by means of the power adapter. Select an appropriate unswitched, grounded AC

facility outlet so as to avoid any future inadvertent power interruptions. Use the following

procedure to apply AC power:

1. Connect the female end of the supplied IEC AC power adapter cable to the power receptacle

on the back of the switch.

2. Connect the AC power adapter cable to the DC jack.

When you apply power, the green Power LED on the switch front panel illuminates.

Note: Ethernet specifications limit the cable length between the switch and the attached

device to 100 m (328 ft.).

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 37 38

No comments

Hawking-technology 202-10248-01 User Manual Page 27